Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I connected via Modbus TCP/IP to WAGO PLC.
I am using Modbus Master simulator and I've got problem with reading coils.
I can't see any changes when I query registers or while using another simulator it shows me error (pic)
Have you ever had such error during reading or writing?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I connected via Modbus TCP/IP to WAGO PLC.
I am using Modbus Master simulator and I've got problem with reading coils.
I can't see any changes when I query registers or while using another simulator it shows me error (pic)
Have you ever had such error during reading or writing?