Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have some troubles getting started with programming via tcpip in codesys. I would like to have a Festo PLC (CDPX module with soft plc) communication with a device that has an ethernet interface supporting Ascii over ethernet. Anybody knows about how to get started? Anybody has some codesys project samples that shows how to setup communication and how to transfere data. Every help is appreciated.
Thanks.
\Morton
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
If you use V3, then look at the CAA Netbase library (Use Case library)
You can also find an example in the store (store.codesys.com). See the Halcon demo application.
The help will also provide you some information.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi.
I have some troubles getting started with programming via tcpip in codesys. I would like to have a Festo PLC (CDPX module with soft plc) communication with a device that has an ethernet interface supporting Ascii over ethernet. Anybody knows about how to get started? Anybody has some codesys project samples that shows how to setup communication and how to transfere data. Every help is appreciated.
Thanks.
\Morton
If you use V3, then look at the CAA Netbase library (Use Case library)
You can also find an example in the store (store.codesys.com). See the Halcon demo application.
The help will also provide you some information.