Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have a problem with TwinCAT 3. When I want to rename a variable, the name is changed only at this position, but not in other places where that variable is used in the software. I have already checked in the TwinCAT options (Tools > Options) under category TwinCAT > PLC Environment > Refactoring but everything is already turned on. Also in the Beckhoff documentation is written that when I select variable under refactoring there is rename option, but in my case, there is no rename (See in the picture).
Thank you in advance,
Best regards, Mateja
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello everyone,
I have a problem with TwinCAT 3. When I want to rename a variable, the name is changed only at this position, but not in other places where that variable is used in the software. I have already checked in the TwinCAT options (Tools > Options) under category TwinCAT > PLC Environment > Refactoring but everything is already turned on. Also in the Beckhoff documentation is written that when I select variable under refactoring there is rename option, but in my case, there is no rename (See in the picture).
Thank you in advance,
Best regards, Mateja