Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi,
you could check with this version: https://store.codesys.com/device-reader.html
if the licenses are available.
With upcoming 3.5SP15 Version it will be possible to check without these application from CODESYS store.
BR
Edwin
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I did download and checked for the existing licenses.
Looks like I don't need any licence for my Janztec controller.
Thank you very much for your time!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello everybody,
I am testing CANopen on CodeSYS.
The Device under use is Janz emCONTROL Dynamic 64bit
The CAN bus is fully functional, up and running.
However, neither the CANopen_Manager-CANopenRemoteDevice nor the CANopenLocalDevice are running.
Their status is always "Not running".
I did check for the licenses on my Janztec. Turns out there is CANopen licence is available only for CANopen Master.
Is the CANopen Slave not running because of the missing licence?
Any idea how I should go about it? Has anyone had a similar situation? What did you do about it?
Any and every input is highly valuable.
Hi,
you could check with this version:
https://store.codesys.com/device-reader.html
if the licenses are available.
With upcoming 3.5SP15 Version it will be possible to check without these application from CODESYS store.
BR
Edwin
I did download and checked for the existing licenses.
Looks like I don't need any licence for my Janztec controller.
Thank you very much for your time!