Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

SMC_REGULATOR_OR_START_NOT_SET

Omar Ampyx
2019-02-20
2019-02-21
  • Omar Ampyx - 2019-02-20

    Hi guys,

    I turn an axis using MC_Velocity and everything goes fine until a certain speed. Few seconds after running at that speed it returns the error SMC_REGULATOR_OR_START_NOT_SET. i don't get any clear answer from the help file "Controller enable not done or brake applied".

    Any idea what could be causing this?

    Thank you in advance, Omar

     
  • eschwellinger

    eschwellinger - 2019-02-21

    Hi,
    could you check the error history of the axis
    (in the axisref)

    BR
    Edwin

    IMG: DrivefbErrorpng.png

     

Log in to post a comment.