Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have no idea right now.
I visualize a Gantry Cutter system with a SMC_VISU_GantryCutter2. So far so good. Now the axes are swapped in the visual representation. In my configuration the Gantry axis is the X-axis and the and the connecting axis is the y-axis. Is there a possibility that you can change the assignment in the settings in the VISU or do I have to make the assignment in the hardware configuration? I can't find a point in the properties where I could somehow match the axles
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have no idea right now.
I visualize a Gantry Cutter system with a SMC_VISU_GantryCutter2. So far so good. Now the axes are swapped in the visual representation. In my configuration the Gantry axis is the X-axis and the and the connecting axis is the y-axis. Is there a possibility that you can change the assignment in the settings in the VISU or do I have to make the assignment in the hardware configuration? I can't find a point in the properties where I could somehow match the axles