Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Can someone tell me if it is possible to, as a user, add modules to the Profinet GSDML?
The case is this, I am using a Pi as an IO simulator with an S7-1500 over Profinet. Problem is I would like to have more module choices than "x 8bit", "x Float32", etc. I can see where I could edit the GSDML after creation, but that would only be applicable to the S7-1500 side (as I see it).
I would like to add something like "x Word16", and "x Int16" for example (on both sides of course). Is this even possible or is my only option to use what is available as default?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Greetings,
Can someone tell me if it is possible to, as a user, add modules to the Profinet GSDML?
The case is this, I am using a Pi as an IO simulator with an S7-1500 over Profinet. Problem is I would like to have more module choices than "x 8bit", "x Float32", etc. I can see where I could edit the GSDML after creation, but that would only be applicable to the S7-1500 side (as I see it).
I would like to add something like "x Word16", and "x Int16" for example (on both sides of course). Is this even possible or is my only option to use what is available as default?
I see there has been a lot of views. Is this just something that cannot be changed, or does nobody know?