Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Thank you for answer.
Its my own DIY I/O module. I want increase baudrate to minimize delays.
Could you also answer for my second question? Maybe simple example?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Modbus COM, 3.5.11.20 (latest). On tab SerialPort Parameteres there is no baudrate 38400.
But you can set it with tab General, and seems like it's working.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello!
It is possible to change serial port baudrate to value that is not in list? I want use 250k but it is not on selectable list.
Second question is, when we create new ModbusChannel there is option to set trigger from "application" but how to use this? any example?
Thanks for answer.
Nobody answer?
Up.
Edwin, please answer.
Hi,
not possible without an improvement but not sure if this will be implemented,
which modbus slave to you have with this strange baudrate?
BR
Edwin
Thank you for answer.
Its my own DIY I/O module. I want increase baudrate to minimize delays.
Could you also answer for my second question? Maybe simple example?
Hi,
see my screenshots
BR
Edwin
Thank you.
Another question about Modbus.
Modbus COM, 3.5.11.20 (latest). On tab SerialPort Parameteres there is no baudrate 38400.
But you can set it with tab General, and seems like it's working.