Control Stepper Driver

apakrat
2018-10-06
2019-04-12
  • apakrat - 2018-10-06

    Hi everyone, I'm newbie here. Can someone teach me how to control the stepper driver in the picture below? Should i use raspberry?
    Thanks.

    IMG: 43225981_717944511873354_9051279247129182208_n.jpg

     
  • eschwellinger

    eschwellinger - 2018-10-06

    Hi,
    this is puls/direction
    one option is to do it by Ethercat and EL2521
    BR
    Edwin

    IMG: EL25xx.png

    IMG: EL2521.jpg

     
  • apakrat - 2018-10-08

    Thanks.

     
  • apakrat - 2018-10-08

    Hi edwin, did you have some example about it? I've researched in google but i still don't know how to use those device (EK1100 and EL2521). Base on your picture, i need to buy EK1100 right? But why i need it? Cause i can easy give driver pulses with GPIO of Rasberry.

     
  • eschwellinger

    eschwellinger - 2018-10-09

    Hi,
    yes you need to have EK1100 and EL2521.
    Using GPIOs is maybe possible depend on how fast you need to move the motor. ( and you need to convert the 3.3V GPIOs to 5V whatever your puls/dir interface is using).

    We have no ready to use driver for GPIO's in combination with SoftMotion. So the only way to do it with PLCopen FB's and Robotic/Motion is to use these.

    BR
    Edwin

     
  • apakrat - 2018-10-09

    Thanks you.

     
  • johnlee - 2019-04-12

    Edwin Schwellinger hat geschrieben:
    Hi,
    yes you need to have EK1100 and EL2521.
    Using GPIOs is maybe possible depend on how fast you need to move the motor. ( and you need to convert the 3.3V GPIOs to 5V whatever your puls/dir interface is using).
    We have no ready to use driver for GPIO's in combination with SoftMotion. So the only way to do it with PLCopen FB's and Robotic/Motion is to use these.
    BR
    Edwin

    Hi Edwin,

    If possible using wago module rather than beckhoff?

    Thank you
    John Lee

     
  • eschwellinger

    eschwellinger - 2019-04-12

    Hi John,
    we have no SoftMotion driver for the Wago modules...!

    BR
    Edwin

     

Log in to post a comment.