Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
After an program download, all ethercat slaves sends his startup sdo.
If the slaves have f. Ex 150 startup sdos, and we have 3 slaves, the startup takes a lot of time. (With task cycle of 10 ms it could takes 60s, but with 5 ms only 15s...).
It is possible acvelerate it?
There exist any configuration parameter to send the parameters only the first downolad?
Thanks
Sent from my Moto G (5S) Plus using Tapatalk
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi.
After an program download, all ethercat slaves sends his startup sdo.
If the slaves have f. Ex 150 startup sdos, and we have 3 slaves, the startup takes a lot of time. (With task cycle of 10 ms it could takes 60s, but with 5 ms only 15s...).
It is possible acvelerate it?
There exist any configuration parameter to send the parameters only the first downolad?
Thanks
Sent from my Moto G (5S) Plus using Tapatalk