Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I need my programming to have origins different from the machine source.
Need to keep machine origin for soft limit, tool change, safety move ..
The other sources would change according to the movement rate (SMC_ControlAxisByPos).
Do you have any specific function blocks for this?
Thank you.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I need my programming to have origins different from the machine source.
Need to keep machine origin for soft limit, tool change, safety move ..
The other sources would change according to the movement rate (SMC_ControlAxisByPos).
Do you have any specific function blocks for this?
Thank you.