Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
does softmotionCNC support cordinate rotation commands G68/G69?
I do get a syntax error when I use them. It is not clear to me if it is included inside DIN 66025. Some command lists i found online include them some do not.
Any ideas on how to handle this command?
Kind regards
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Originally created by: axilleas
Dear all,
does softmotionCNC support cordinate rotation commands G68/G69?
I do get a syntax error when I use them. It is not clear to me if it is included inside DIN 66025. Some command lists i found online include them some do not.
Any ideas on how to handle this command?
Kind regards