Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am working with Lenze I700 drives in sync position mode. Codesys sends the speed feedforward in encoderPulses/s and i700 interprets it as rpm factorized in 480000/2^32. That causes an following error proportional at speed. There exist any parameter to solve that?
Thanks
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Dears.
I am working with Lenze I700 drives in sync position mode. Codesys sends the speed feedforward in encoderPulses/s and i700 interprets it as rpm factorized in 480000/2^32. That causes an following error proportional at speed. There exist any parameter to solve that?
Thanks
Hi Josep M. Rams
Have you found a solution I have the same problem with following error.
Thanks
Hi.
Modifying fFactorvel in ref_axe it works (But not seems to be a elegant method ), but I cannot know how to set the addTorque FF.
Thank you for info about your solution.