Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
i have a question to write Paramter to a DeviceNet Slave.
Can somebody give me an example how I have to write Paramter from my plc program to the Hardware (DeviceNet Slave)?
I have to change the paramter configuration several times during a process.
The structure of the Hardware is:
-NetX_CANbus
---CIFX_DNM
-----SlaveModul (here the Parameter config. must be changed)
Thanks in advance.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
any Progress on this issue? I have a similar one with a B&R POWERLINK-Slave. There is a configuration option but the parameters are never transfered to the Hardware.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello togehter,
i have a question to write Paramter to a DeviceNet Slave.
Can somebody give me an example how I have to write Paramter from my plc program to the Hardware (DeviceNet Slave)?
I have to change the paramter configuration several times during a process.
The structure of the Hardware is:
-NetX_CANbus
---CIFX_DNM
-----SlaveModul (here the Parameter config. must be changed)
Thanks in advance.
Hello,
any Progress on this issue? I have a similar one with a B&R POWERLINK-Slave. There is a configuration option but the parameters are never transfered to the Hardware.