Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Raspberry PI as ProfinetDevice project example

Anonymous
2017-04-11
2017-04-12
  • Anonymous - 2017-04-11

    Originally created by: OW_RPi

    Hello,

    I wanted to try my RPI as ProfinetDevice. I therefore downloaded the project example and followed the described instructions.
    Unfortunately, my CODESYS Profinet Device is not running and is displayed with error sign even though the PN-Device Status is in RUN-Mode.

    In my sencond RPi which I tried to use as ProfinetMaster, I cannot find the slave device (no problems with other devices).

    I work with the latest version of codesyscontrol (V3.5.10.2).

    Any ideas?

    Best regards,
    Oleg

    IMG: Unbenannt.JPG

     
  • eschwellinger

    eschwellinger - 2017-04-11

    Hi,
    is the ethx Adapter on PN device Pi in 'promisc' mode?
    Check the logger in the plc logger on pn device PI.

    Is there a message on missing PN device license?

    BR
    Edwin

     
  • Anonymous - 2017-04-12

    Originally created by: OW_RPi

    Hello Edwin,

    I added the 'promisc' command to /etc/rc.local. Now everything is just fine.
    Unfortunately, I did that on my PN-Master first instead of the PN-Device.

    Thank you for your support!

    Best regards,
    Oleg

     

Log in to post a comment.