Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Is it possible to set a "Value" entry on the "GPIO Parameters" tab to a fixed value?
I would for instance like to use GPIO4 only as an input and never as an output.
I can set the default value, and limit the possibilities of the Value field to "Input" but I still have to
set the (only possible) value in the configuration.
Is it possible to skip or inhibit bit field entries on the "GPIOs I/O Mapping" tab?
Since GPIO 0 till 3 can not be used, it's useless to be able to assign a variable to it.
So I would like to inhibit those fields somehow (only when using BIT entries, not if the
bit is part of e.g. a Word, then the programmer is responsible to handle the bits properly).
Regards,
Ruud
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Is it possible to set a "Value" entry on the "GPIO Parameters" tab to a fixed value?
I would for instance like to use GPIO4 only as an input and never as an output.
I can set the default value, and limit the possibilities of the Value field to "Input" but I still have to
set the (only possible) value in the configuration.
Is it possible to skip or inhibit bit field entries on the "GPIOs I/O Mapping" tab?
Since GPIO 0 till 3 can not be used, it's useless to be able to assign a variable to it.
So I would like to inhibit those fields somehow (only when using BIT entries, not if the
bit is part of e.g. a Word, then the programmer is responsible to handle the bits properly).
Regards,
Ruud