Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Dear All,
As titled, may i know how to make PID function works in inverse mode? I would like to make a PID blower control where the set value is wind pressure. In normal mode, blower speed need faster to make higher pressure. But when i select reverse mode, blower speed need slower to make higher pressure. In Tia portal , there is a bit for reverse mode. So i wonder whether reverse mode is available in CoDeSys or not. I had been searched in internet about the method but no result. Hope you all can help me about this. Thank you
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Dear All,
As titled, may i know how to make PID function works in inverse mode? I would like to make a PID blower control where the set value is wind pressure. In normal mode, blower speed need faster to make higher pressure. But when i select reverse mode, blower speed need slower to make higher pressure. In Tia portal , there is a bit for reverse mode. So i wonder whether reverse mode is available in CoDeSys or not. I had been searched in internet about the method but no result. Hope you all can help me about this. Thank you
what PID function is used.
when you make the P action negative it will work.
This is standard theory.
Very good, worked well on my application only, set P as negative value to invert the control of the PID function block.