Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have no errors in the program and the axis state shows: ''no power / 1''
I am trying to change the ''controllerenableset'' to activate it without success. I have tried several drives
so I am pretty sure that it is in the program itself.
I am new to using Epas4 (CodeSys) so excuse my ignorance.
Does anybody have an idea?
Thanks
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi you all,
I am trying to tests Elau drives with a C200 controller. I am using the program suggested by this topic:
http://forum.codesys.com/viewtopic.php?t=2024#p4130
I have no errors in the program and the axis state shows: ''no power / 1''
I am trying to change the ''controllerenableset'' to activate it without success. I have tried several drives
so I am pretty sure that it is in the program itself.
I am new to using Epas4 (CodeSys) so excuse my ignorance.
Does anybody have an idea?
Thanks