Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello, i have problem with Russian char in Dialog title in standart Numpad dialog....
I set in Visualisation config using UTF, if i use some 'ััะพ ัะพ ะฟะพ ััััะบะธ' (ascii) then i have bed chars in title, if use "ััะพ ัะพ ะฟะพ ััััะบะธ" (utf) then again have bed chars.
What i doing wrong?
I use 3.5.6.0 version VisuDialogs.librrary
I event try rewrite VisuDialogs.librrary and change string to wstring in dialog tiltle VAR in Numpad and in interface declaration. Then install new lib as version 3.5.6.1 and try to compile with it but have error can't convert string to wstring in new lib. But when i chek it before install it was ok, what it can be?
Thank you.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello, i have problem with Russian char in Dialog title in standart Numpad dialog....
I set in Visualisation config using UTF, if i use some 'ััะพ ัะพ ะฟะพ ััััะบะธ' (ascii) then i have bed chars in title, if use "ััะพ ัะพ ะฟะพ ััััะบะธ" (utf) then again have bed chars.
What i doing wrong?
I use 3.5.6.0 version VisuDialogs.librrary
I event try rewrite VisuDialogs.librrary and change string to wstring in dialog tiltle VAR in Numpad and in interface declaration. Then install new lib as version 3.5.6.1 and try to compile with it but have error can't convert string to wstring in new lib. But when i chek it before install it was ok, what it can be?
Thank you.