Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Dear forum,
I have install a PEAK-Can usb device and it's works fine under CODESYS V3.
I'm looking for a solution to read from CAN Layer2 network. Is this possible or can V3 only work with CANopen?
And I have no idea to read the state of the CANopen like the state, busload and so on. I can't find any library for this.
Who can help me.
]:-> chrischanHH
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Dear forum,
I have install a PEAK-Can usb device and it's works fine under CODESYS V3.
I'm looking for a solution to read from CAN Layer2 network. Is this possible or can V3 only work with CANopen?
And I have no idea to read the state of the CANopen like the state, busload and so on. I can't find any library for this.
Who can help me.
]:-> chrischanHH
Hi,
check this example in the store your can layer 2 communication:
http://store.codesys.com/can-bus-example.html
BR
Edwin
Thanks for your help
]:-> chrischanHH