Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello,
I bought wago 750-837 with the ability to work as a CANopen master. I need to communicate with two beckhoff input and output cards. I do not have much experience with CANopen. Can you tell me how to configure wago as a CANopen master in Codesys 2.3
When I create a project with device 750-837, I can not add any device in the plc configuration (see picture). I need to add beckhoff cards.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I bought wago 750-837 with the ability to work as a CANopen master. I need to communicate with two beckhoff input and output cards. I do not have much experience with CANopen. Can you tell me how to configure wago as a CANopen master in Codesys 2.3
When I create a project with device 750-837, I can not add any device in the plc configuration (see picture). I need to add beckhoff cards.