Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I would like to use analog feedback for positioning at hydraulic axes control. If there is a position control function block that is experienced please share it.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I would like to use analog feedback for positioning at hydraulic axes control. If there is a position control function block that is experienced please share it.
w www.oscat.de w
read and learn
and yes several analog blocks for this
if difficult application use fuzzy control.