CODESYS - the IEC 61131-3 automation software
https://forum.codesys.com/

CNCdirect with beckhoff el2512
https://forum.codesys.com/viewtopic.php?f=6&t=9792
Page 1 of 1

Author:  hknappe52 [ Sun Jun 02, 2019 11:21 pm ]
Post subject:  CNCdirect with beckhoff el2512

hello,
I have added to the CNCdirect sample program from the tutorial (it works fine) with beckhoff hardware
-EK1000
-2x EL2512
Now I receive on P1 and P2 (SMC_ControlAxisByPos) a bError true signal
the parameter iErrorID says: SMC_MS_axis_in_errorstop

what is wrong?
Please advise

Holger

Author:  Edwin Schwellinger [ Mon Jun 03, 2019 6:09 am ]
Post subject:  Re: CNCdirect with beckhoff el2512

Hi,
SoftMotion does not work in simulation you could try to add the axis to 'SoftMotion general Axis pool'
and then login either to your Pi or you could SoftMotion Win on your CODESYS pc to login with your applicaiton.

BR
Edwin

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/