Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello all,
I want to communicate two PLCs using CANOpen protocol, I have configured one PLC as CANOpen Master,
one PLC as CANOpen Slave.
I have attached image file of both side setting.
So please guide me.
Thanks in advance.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello all,
I want to communicate two PLCs using CANOpen protocol, I have configured one PLC as CANOpen Master,
one PLC as CANOpen Slave.
I have attached image file of both side setting.
So please guide me.
Thanks in advance.
Hello ,
Maybe there is an example in the shop.
If you have a Lan network then a Network variable is easier to do and quicker.