CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum by 3S-Smart Software Solutions GmbH | A member of the CODESYS Group
Deutsche Version English version russian version 
It is currently Wed Oct 16, 2019 7:51 am

All times are UTC+01:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Wed Mar 20, 2019 1:24 pm 
Offline

Joined: Tue Feb 27, 2018 11:50 am
Posts: 11
Hello !

I have two vitual axes, Master and a slave.
- They run in syn for master value (0 to 360),
- Then they are decoupled through 'MC_CamOut' and
- Then master and slave are stopped
Above three steps work fine.

Requirement:
I want to abort the movement of master and thus the slave in syn should also abort at that point.
ABorting method is called separately when a specific condition is satisfied.

Issue:
By doing so, error occurs. 'SMC_FB_WASNT_CALLED_DURING_MOTION '

Please suggest a solution.
Attachment:
issue1.PNG

Attachment:
issue2.PNG

Attachment:
issue3.PNG

Attachment:
issue4.PNG


You do not have the required permissions to view the files attached to this post.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited