CODESYS - the IEC 61131-3 automation software
https://forum.codesys.com/

What's the meaning of 'M' LOGO?
https://forum.codesys.com/viewtopic.php?f=6&t=9560
Page 1 of 1

Author:  nozomiw [ Thu Feb 28, 2019 3:21 am ]
Post subject:  What's the meaning of 'M' LOGO?

What's the meaning of 'M' LOGO?

Author:  ph0010421 [ Thu Feb 28, 2019 7:01 am ]
Post subject:  Re: What's the meaning of 'M' LOGO?

From the Help:
Indicates that this address has been edited and fixed. If the arrangement of the device objects in the device tree changes, CODESYS does not adapt this address automatically

Author:  nozomiw [ Fri Mar 01, 2019 1:00 am ]
Post subject:  Re: What's the meaning of 'M' LOGO?

Thank you!

Author:  Edwin Schwellinger [ Sun Mar 03, 2019 9:56 am ]
Post subject:  Re: What's the meaning of 'M' LOGO?

You could remove it by delete the manual changed %QBxxx,
the the automatic address calc will be started ( if all manual changed addresses are removed - then this 'M' will disapear)
I would recommend in most of the cases to let CODESYS decide/calc / the address asignment
BR
Edwin

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/