CODESYS - the IEC 61131-3 automation software
https://forum.codesys.com/

SMC_VISU_GantryCutter2
https://forum.codesys.com/viewtopic.php?f=6&t=9522
Page 1 of 1

Author:  xyungelöst [ Thu Feb 14, 2019 4:17 pm ]
Post subject:  SMC_VISU_GantryCutter2

I have no idea right now.
I visualize a Gantry Cutter system with a SMC_VISU_GantryCutter2. So far so good. Now the axes are swapped in the visual representation. In my configuration the Gantry axis is the X-axis and the and the connecting axis is the y-axis. Is there a possibility that you can change the assignment in the settings in the VISU or do I have to make the assignment in the hardware configuration? I can't find a point in the properties where I could somehow match the axles :cry:

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/