CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum by 3S-Smart Software Solutions GmbH | A member of the CODESYS Group
Deutsche Version English version russian version 
It is currently Wed Oct 23, 2019 7:02 pm

All times are UTC+01:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
 Post subject: SMC_VISU_GantryCutter2
PostPosted: Thu Feb 14, 2019 4:17 pm 
Offline

Joined: Tue Dec 06, 2016 10:38 pm
Posts: 3
I have no idea right now.
I visualize a Gantry Cutter system with a SMC_VISU_GantryCutter2. So far so good. Now the axes are swapped in the visual representation. In my configuration the Gantry axis is the X-axis and the and the connecting axis is the y-axis. Is there a possibility that you can change the assignment in the settings in the VISU or do I have to make the assignment in the hardware configuration? I can't find a point in the properties where I could somehow match the axles :cry:


You do not have the required permissions to view the files attached to this post.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited