Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi,
I'm looking for a way to interpret the G code provided by a post processor.I can not understand the parameters T for tool and S for speed spindle.Is this a limit of softmotion or we can bypass it in using another compiler.
The customer uses POWER AUTOMATION but wants to stop using it.
Looking forward to your return ...
Ludovic Taillez
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I'm looking for a way to interpret the G code provided by a post processor.I can not understand the parameters T for tool and S for speed spindle.Is this a limit of softmotion or we can bypass it in using another compiler.
The customer uses POWER AUTOMATION but wants to stop using it.
Looking forward to your return ...
Ludovic Taillez