Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Axis Automatic mapping not working

Omar Ampyx
2018-10-18
2018-10-18
  • Omar Ampyx - 2018-10-18

    Hi everyone,

    Checking the 'automatic mapping' box on AXIS_REF_ETC_DS402_CS does not communicate any position, speed, torque parameters with the drive, the only thing being communicated is the status and control word.

    Looking online inside the axis struct, you can see that the addresses on the mapping entries are missing (see screenshot).

    Anybody knows why this is happening?

    Gr, Omar

    IMG: undefined mapping entry.JPG

     
  • Omar Ampyx - 2018-10-18

    Hi everyone,

    I found the issue, I didnt define the expected PDOs on the ETC slave to which the axis was connected. If the axis cant find the expected PDOs it does not generate an error, it just maps to a null address, so no communication is performed.

    Once I defined the right PDOs on the slave, then toggling the automatic mapping checkbox maps the PDOs to the axis parameters as expected.

    Cheers, Omar

     

Log in to post a comment.