Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Function of MC_TouchProbe...

2018-07-17
2018-07-19
  • JamesPeng-TW - 2018-07-17

    Hi~

    I'm currently working in SM3_Basic, 4.3.2.0 and control the axis in CiA402 axis.

    For the FB "MC_TouchProbe", I could only get a single measurement function.
    But most of the modern ethercat servo drive support permanent measurement(usually set Touch Probe Function control word bit 1 := 1) which means execute edge activates function until abortion by MC_AbortTrigger. I have tried to modify the Touch Probe Function control word in the program through direct access the address, but it is not changed. Is there any other way I could do this?
    Any comment/ advice is appreciated and thanks in advance.

    James

     
  • eschwellinger

    eschwellinger - 2018-07-19

    Hi James,

    hm.. you could remove the Objects from control word /pdo data and use SDO's to start the touchprobing manually.
    Not nice but maybe works..

    BR
    Edwin

     

Log in to post a comment.