Author |
Message |
smb2700
|
PostPosted: Sat Jun 30, 2018 11:45 am |
|
Joined: Sat Jun 23, 2018 10:47 am Posts: 2
|
Hi, I have a problem with the use of a new servomotor and drive, with a 20 bit encoder if I try to move the motor with MC_MoveRelative I have the following error: SMC_ERROR.SMC_DI_HWLIMITS_EXCEEDED. I try to check on the help but is missing. With other drive + servos I do not have these problems.
Currently I installed: - CODESYS V3.5 SP12 Patch 1 - CODESYS SoftMotion 4.3.1.0 - CODESYS Control for BeagleBone SL
Attached the image with the error. How can I solve the problem ?? Am I wrong or is it a bug?
Thank you
You do not have the required permissions to view the files attached to this post.
|
|
Top |
|
 |
alwoso
|
PostPosted: Mon Jul 02, 2018 8:04 am |
|
Joined: Mon Nov 03, 2014 7:15 am Posts: 48
|
Hi smb2700!
Did you check the drive settings? Does the drive itself give a fault message, too? If there is no fault on the drive, check the PDO-mapping - maybe there is a mismatch between the drive's mapping and the mapping in your program....
Good luck!
Alfred
|
|
Top |
|
 |
smb2700
|
PostPosted: Tue Jul 03, 2018 5:44 pm |
|
Joined: Sat Jun 23, 2018 10:47 am Posts: 2
|
Hi Alfred, the problem was in the setting of digital inputs. I remaped inserting them, and this led me to error. Since I have not yet connected my proximity switches to do these tests, I have inverted the status of the inputs on the drive, and it works.
|
|
Top |
|
 |