CODESYS - the IEC 61131-3 automation software
https://forum.codesys.com/

G68 support
https://forum.codesys.com/viewtopic.php?f=6&t=8910
Page 1 of 1

Author:  axilleas [ Wed Jun 13, 2018 7:28 am ]
Post subject:  G68 support

Dear all,

does softmotionCNC support cordinate rotation commands G68/G69?
I do get a syntax error when I use them. It is not clear to me if it is included inside DIN 66025. Some command lists i found online include them some do not.
Any ideas on how to handle this command?

Kind regards

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/