Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Feedforwards

2018-02-15
2018-04-03
  • josepmariarams - 2018-02-15

    Dears.

    I am working with Lenze I700 drives in sync position mode. Codesys sends the speed feedforward in encoderPulses/s and i700 interprets it as rpm factorized in 480000/2^32. That causes an following error proportional at speed. There exist any parameter to solve that?

    Thanks

     
  • DHV - 2018-03-01

    Hi Josep M. Rams

    Have you found a solution I have the same problem with following error.

    Thanks

     
  • josepmariarams - 2018-03-06

    Hi.

    Modifying fFactorvel in ref_axe it works (But not seems to be a elegant method ), but I cannot know how to set the addTorque FF.

    IMG: Captura de 2018

     
  • DHV - 2018-04-03

    Thank you for info about your solution.

     

Log in to post a comment.