CODESYS - the IEC 61131-3 automation software
https://forum.codesys.com/

drive configuration question.
https://forum.codesys.com/viewtopic.php?f=6&t=8534
Page 1 of 1

Author:  Josep M. Rams [ Sat Jan 27, 2018 10:23 am ]
Post subject:  drive configuration question.

Hi.

Anybody knows how could configure I a drive via Codesys.

I can see the parameters via coe online and I have the startup parameters, but there exist the posibility of change parameters in online mode (As coe online allows to see the parameters iD like to change its).

Thanks

Author:  Edwin Schwellinger [ Sat Jan 27, 2018 4:43 pm ]
Post subject:  Re: drive configuration question.

Hi,
I would use:
SMC3_ETC_WriteParameter_CoE

BR
Edwin

Author:  Josep M. Rams [ Sat Jan 27, 2018 7:26 pm ]
Post subject:  Re: drive configuration question.

Thanks Edwin.

In any case, is ig planning to change the drives parameterization via coe online?

Thanks

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/