Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am sucessfull in running machine by using CNC editor.
But i just want to ask you that how can we again empty the machine buffer for next CNC program.
After going in online mode, i make some movement by my machine. But when i do "log out" and make some changes in CNC editor (ie X,Y & Z cordinates) my machine does not understand new cordinate and it runs on the previous coordinates. But when i completely shut down my machine and switched it back on than it understand my new coordinate data. This could because of the prevous data does't delete.
Probability i have delivered my problem very clearly. If anyone knows how to solve it than please let me know .
Thankx
Best Regards
Tahir
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I am sucessfull in running machine by using CNC editor.
But i just want to ask you that how can we again empty the machine buffer for next CNC program.
After going in online mode, i make some movement by my machine. But when i do "log out" and make some changes in CNC editor (ie X,Y & Z cordinates) my machine does not understand new cordinate and it runs on the previous coordinates. But when i completely shut down my machine and switched it back on than it understand my new coordinate data. This could because of the prevous data does't delete.
Probability i have delivered my problem very clearly. If anyone knows how to solve it than please let me know .
Thankx
Best Regards
Tahir