Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
i hav been run my machine by using "FUNCTION BLOCKS" (i.e Moveabsolute, Move relative...... ).
Now i am moving towards a step forward. I have managed to run my machine ( x & y direction )using CNC editor. But by using CNC editor there is kind of very bad vibration in my machine which were not the case when i was using Fuction blocks.
What should i do to stop this vibration???
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
i hav been run my machine by using "FUNCTION BLOCKS" (i.e Moveabsolute, Move relative...... ).
Now i am moving towards a step forward. I have managed to run my machine ( x & y direction )using CNC editor. But by using CNC editor there is kind of very bad vibration in my machine which were not the case when i was using Fuction blocks.
What should i do to stop this vibration???