Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Can handle an error rating that adds up or subtracts each time the axis changes direction of rotation.This can be useful when the ball screw has a particularly painful play when doing Circles on a machining center.
thank you in advance
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Can handle an error rating that adds up or subtracts each time the axis changes direction of rotation.This can be useful when the ball screw has a particularly painful play when doing Circles on a machining center.
thank you in advance
Hi
Look for a parameter named backlash. I think that I have seen this parameter in some configuration.
It is possible that I have seen it in Lenze Copesys implementation, but I am not sure.
I am sorry becaise the answer is not so clear as you need, but...