Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Error positionnement axe

ludo10quad
2017-07-22
2017-08-10
  • ludo10quad - 2017-07-22

    Can handle an error rating that adds up or subtracts each time the axis changes direction of rotation.This can be useful when the ball screw has a particularly painful play when doing Circles on a machining center.
    thank you in advance

     
  • josepmariarams - 2017-08-10

    Hi

    Look for a parameter named backlash. I think that I have seen this parameter in some configuration.

    It is possible that I have seen it in Lenze Copesys implementation, but I am not sure.

    I am sorry becaise the answer is not so clear as you need, but...

     

Log in to post a comment.