Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm want to test softmotion on Berghof DC2007 and while I choose a Berghof MX6 SoftMotion Control in Codesys I can not conecct with the PLC - I see it after network scan but the "OK" is grayed. I can connect with the device if I choose the PLC without softmotion control...
What is wrong - on Codesys store it says that DC2007 is softmotion capable???
PS. Curently there is no softmotion license installed on that PLC but I want to try it in demo mode(Soft motion light runs on it in demo mode without a license).
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Originally created by: gnom4
Hi
I'm want to test softmotion on Berghof DC2007 and while I choose a Berghof MX6 SoftMotion Control in Codesys I can not conecct with the PLC - I see it after network scan but the "OK" is grayed. I can connect with the device if I choose the PLC without softmotion control...
What is wrong - on Codesys store it says that DC2007 is softmotion capable???
PS. Curently there is no softmotion license installed on that PLC but I want to try it in demo mode(Soft motion light runs on it in demo mode without a license).
Hi,
think you need a different Firmware in the DC2007?
I would recommend to contact Berghof.
BR
Edwin
Originally created by: gnom4
Berghof representative in my country told me that the reason that I cannot conect is that I don't have a Softmotion license installed on the PLC...
Can that be the reason No demo mode