Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello
Is it possible to get to the CAM points from within the program?
Thanks
Paul
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Anonymous
-
2016-03-29
Originally created by: ph0010421
Maybe I should explain.
I'd like to mathematically place cam points during runtime.
I can declare a cam in IDE; I just want to move the points at runtime.
Thank you
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Originally created by: ph0010421
Hello
Is it possible to get to the CAM points from within the program?
Thanks
Paul
Originally created by: ph0010421
Maybe I should explain.
I'd like to mathematically place cam points during runtime.
I can declare a cam in IDE; I just want to move the points at runtime.
Thank you