Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm trying to start the first example of the softmotion examples. Described in the Online Help, SoftMotion, Example application, Single-Axis motion control.
I have built without errors
I have started the CODESYS Softmotion win v3 and its running.
When I try Login I get the message No active path defined, and when I scan the network for a controller - none is found. What should I use as active path to the softmotion win v3 controller? In the command window running softmotion win v3 there are listed some ip-addresses, but none of them work as activepath.
what am I doing wrong?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Your device in the project "... V3 64" is slightly different than the device you started "...V3".
Right click on the device in you project and select "update device".
Then select the CODESYS SoftMotion Win V3 (not the 64).
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
TimvH hat geschrieben:
Your device in the project "... V3 " is slightly different than the device you started "...V3".
Right click on the device in you project and select "update device".
Then select the CODESYS SoftMotion Win V3 ().
Ahhhh. Thank's!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
codesys 3.5 SP7
I'm trying to start the first example of the softmotion examples. Described in the Online Help, SoftMotion, Example application, Single-Axis motion control.
I have built without errors
I have started the CODESYS Softmotion win v3 and its running.
When I try Login I get the message No active path defined, and when I scan the network for a controller - none is found. What should I use as active path to the softmotion win v3 controller? In the command window running softmotion win v3 there are listed some ip-addresses, but none of them work as activepath.
what am I doing wrong?
Your device in the project "... V3 64" is slightly different than the device you started "...V3".
Right click on the device in you project and select "update device".
Then select the CODESYS SoftMotion Win V3 (not the 64).
Ahhhh. Thank's!