Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

A problem about CNC_Editor

dgp
2005-07-21
2005-09-05
  • dgp - 2005-07-21

    When I use CNC_Editor, I find the radius is always 100 in G02 and G03. I do not understand. I hope someone can tell me.

    % comment

    N0001 G01 X30 Y30 F100

    N0001 G02 X40.0 Y 0.0 R100

     
  • eschwellinger

    eschwellinger - 2005-09-05

    dgp hat geschrieben:
    When I use CNC_Editor, I find the radius is always 100 in G02 and G03. I do not understand. I hope someone can tell me.
    % comment
    N0001 G01 X30 Y30 F100
    N0001 G02 X40.0 Y 0.0 R100

    This R100 is the default setting for a g2,g3.

    If you draw it graphical, you can change the radius for the actual drawn element by clicking in the upper window and overwrite the value(R100) in the editor.

    There is a Tracker entry #5213 for an improvement.

    There should be an additional point on the arc which change graphically the radius by dragging this point.

     

Log in to post a comment.