Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I turn an axis using MC_Velocity and everything goes fine until a certain speed. Few seconds after running at that speed it returns the error SMC_REGULATOR_OR_START_NOT_SET. i don't get any clear answer from the help file "Controller enable not done or brake applied".
Any idea what could be causing this?
Thank you in advance, Omar
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi guys,
I turn an axis using MC_Velocity and everything goes fine until a certain speed. Few seconds after running at that speed it returns the error SMC_REGULATOR_OR_START_NOT_SET. i don't get any clear answer from the help file "Controller enable not done or brake applied".
Any idea what could be causing this?
Thank you in advance, Omar
Hi,
could you check the error history of the axis
(in the axisref)
BR
Edwin