Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi all
I wrote a program in codesys V3.5 for an exor PLC and wanted to attach an Uniop eTop 500 series the control system. Has anyone have any idea were can I get a manual how to program the HMI.
Kind regards
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi all
I wrote a program in codesys V3.5 for an exor PLC and wanted to attach an Uniop eTop 500 series the control system. Has anyone have any idea were can I get a manual how to program the HMI.
Kind regards
this question is in wrong forum, post it in V3 uphere,
manual is available with F1 (helpfile)
is it possible to use Codesys 3.5 with eTop500 Exor? I always used v.2.3