Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Uniop Etop 500 series programming with Codesys

saimir
2014-07-24
2014-11-13
  • saimir - 2014-07-24

    Hi all
    I wrote a program in codesys V3.5 for an exor PLC and wanted to attach an Uniop eTop 500 series the control system. Has anyone have any idea were can I get a manual how to program the HMI.
    Kind regards

     
  • shooter - 2014-07-28

    this question is in wrong forum, post it in V3 uphere,
    manual is available with F1 (helpfile)

     
  • hki75 - 2014-11-13

    is it possible to use Codesys 3.5 with eTop500 Exor? I always used v.2.3

     

Log in to post a comment.