CODESYS - the IEC 61131-3 automation software
https://forum.codesys.com/

Codesys Control RTE
https://forum.codesys.com/viewtopic.php?f=4&t=8555
Page 1 of 1

Author:  pedrazzi [ Fri Feb 02, 2018 9:21 am ]
Post subject:  Codesys Control RTE

Hi,
i'm trying to run Codesys RTE on an industrial PC with Win7. The installation is ok and I can also Start the PLC.
I make a new project on my laptop with the Codesys Control RTE Devive but I'm not able to can connect with the devive.
I can ping the industrial PC but the Codesys network scan didn't see any device.

Where is my fault, what i miss to do?
thanks
Simone

Author:  Edwin Schwellinger [ Fri Feb 02, 2018 2:18 pm ]
Post subject:  Re: Codesys Control RTE

Hi,
- check if you use Control RTE 64Bit - if yes you need to add the 64Bit device in the CODESYS project an vice versa..
- check if the RTE is properly startet by - go with the mouse on the Task tray Icon - you should see the Network address which have been assigned.
- remove the filter in the CODESYS scan Dialog/Settings to see all found devices on your network.
BR
Edwin

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/