CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum
Deutsche Version English version russian version 
It is currently Tue Nov 21, 2017 4:22 pm

All times are UTC+01:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Tue Oct 02, 2012 6:11 am 
Offline

Joined: Mon Mar 26, 2012 11:18 am
Posts: 1
Hi all,

I need to create a new target for PLCWinNT. This is done by 3S's software MakeTarget.exe.
We are going to simulate HW module in PC laptop by running code in soft PLC, so we need to create a target that works just like the real HW.
This has worked fine until now, when we have a new 32-bit module to simulate.

Its configuration file's (.cfg) root section says that its Data Alignment is 4.
Like this:
[Module.Root]
Alignment=4

All inputs to the MakeTarget.exe are specified in document TSP_Creating_E_V23.pdf.
But this data alignment is not mentioned in the document at all.

How should I take care of it when writing the .txt file that it takes as an input?

Target platform is:
Platform=Intel 386 compatible


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited