Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am using two PM591V2 CPU redundant systems one for RO and One for DEMIN system with ABB Digiviz SCADA through OPC server. Is it possible to connect these four ABB PLCs to DIGIVIZ without using hardware that is in simulation mode? if yes please provide me more information.
Thanks in advance.
Ashish
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
yes it is possible however it will use so much processor power that nothing will happen as the timing will be terrible, like minutes instead of milliseconds so unworkable.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I am using two PM591V2 CPU redundant systems one for RO and One for DEMIN system with ABB Digiviz SCADA through OPC server. Is it possible to connect these four ABB PLCs to DIGIVIZ without using hardware that is in simulation mode? if yes please provide me more information.
Thanks in advance.
Ashish
yes it is possible however it will use so much processor power that nothing will happen as the timing will be terrible, like minutes instead of milliseconds so unworkable.