CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum
Deutsche Version English version russian version 
It is currently Fri Jul 21, 2017 5:41 pm

All times are UTC+01:00




Post new topic  Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Fri Mar 10, 2017 4:06 am 
Offline

Joined: Tue Feb 10, 2015 3:02 am
Posts: 3
Hi,

GPIO After the sample project is booted, DI works normally but DO is not output.

1. It works normally at boot time. (LED On / Off)
2. Upon completion of booting, DI and AI will be normally input. DO (LED) will not react after being turned off.
3. When I connect, the variables change normally, but not the actual LED.
4. Downloading the program again is the same.
5. After adding or deleting variables, download and build the program. (LED blinking)
6. After downloading to the boot project and resetting the power, the same phenomenon is repeated.
7. Even if I test it with EtherCAT, it normally boots. Only DO operates abnormally.
8. Please check the attached project file.
9. The board was BBG(wired) and used version 3.5.10.

Best Regards,

Sam.


You do not have the required permissions to view the files attached to this post.


Top
   
PostPosted: Mon Mar 27, 2017 5:28 am 
Offline

Joined: Tue Feb 10, 2015 3:02 am
Posts: 3
This is presumed to be a licensing problem.
This problem has been fixed after changing the board to a BBG with a license and updating to 3.5.10.20.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC+01:00


Who is online

Users browsing this forum: A. Akkerman and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited